- Current Manual(s)
- Operations Manual - See PowerCore MPC-10
- PowerCore Software Installation Manual (1900003)
PowerVision for Controllers
PowerVision For Controllers is a simplified version of the PowerVision Configuration Studio® PC-based software program suite used to configure controllers and displays. This version lets you create customized configurations for controllers such as the MPC-20, MPC-10 and TEC-10 without needing to know how to write code. It is freely available to anyone that wants to configure a Murphy by Enovation Controls controller.
Downloads:
- PowerVision for Controllers Downloads (Account Required)
- Downloads of PowerVision for Controllers are only available on this site to users with registered accounts. To register for a free account, click here. Having trouble accessing your account? Contact Account Support.
- PowerVision for Controllers Tutorial
- Solid Models
- CE Declaration of Conformity
- CSA Certificate of Compliance
No application information is available at this time.
- Interface:
- Display:
- Monochrome HR-TFT
- 2.7 in./ 68 mm, WQVGA (400 x 240 pixels)
- Languages: English, Spanish, German, French, Italian
- (3) LEDs: green (mode), yellow (warning) and red (shutdown)
- Operator controls:
- (11) Raised silicone keypads, tactile feedback
- (1) Rotary key switch, power on/off
- (1) AGC Fuse, 20A
- Power Supply:
- Operating Voltage: 8-32 VDC, reverse battery polarity and load dump protected
- Cranking Power Holdup: 0 VDC up to 50 mS(also good for brownout/blackout instances)
- Current consumption: Power on in stopped state; 117 mA at 12 VDC. Power on in standby mode; 52 mA at 12 VDC.
- Inputs (9):
- (5) Digital, configurable (active on High, Low, Open)
- (3) Analog, configurable (4-20 mA, 0-5V, resistive or digital ground)
- (1) Frequency, supporting: Magnetic pickup (30 Hz - 10 kHz, 2.0 VAC-120 VAC) and Engine Alternator (30 Hz - 10 kHz, 4.5 VRMS - 90 VRMS)
- Outputs (10):
- (1) Relay, Form C (dry / volt-free), 10A
- (2) Relay, NO (+DC), 10A, (Reserved for Crank & Fuel/ECU Enable)
- (2) Low-side FET (–DC), 1A
- (2) High-side FET (+DC), 1A
- (1) Dedicated Alternator Excitation, +DC, 1A
- (1) Sender Common (-DC)
- (1) Sender Return (+DC)
- Communications:
- (1) CAN: J1939
- (1) RS485: Modbus RTU
- Connectors:
- 21pin, Deutsch HDP24-24-21PE
- 31pin, Deutsch HDP24-24-31PE
- Mating Connectors:
- 21 Position, Deutsch HDP26-24-21SE
- 31 Position, Deutsch HDP26-24-31SE
- Physical/Environmental:
- Enclosure Material: Polycarbonate
- Dimensions (WxHxD): N/A
- Weight: N/A
- IP rating: IP66
- Operating Temperature: -40° to +85° C (-40° to 185° F)
- Storage Temperature: -40° to +85° C (-40° to 185° F)
Comments
0 comments
Please sign in to leave a comment.