Keystart 9620 Series for Engine Controls

No drawings are available at this time.

No compliance documents or certificates are available at this time.

No application information is available at this time.

No media or tutorials are available at this time.

No accessory information is available at this time.

Interface:
- (6) LEDs:
  - (1) Multi-Colored, Multistate indication
  - (5) Red, Fault indication
- Operator controls:
  - (1) Keyswitch
Power Supply:
- Operating Voltage: 7-30 VDC
- Cranking Power Holdup: 5 VDC Minimum (also good for brownout instances)
- Current consumption: <100mA
Inputs (6):
- (4) Digital, Dedicated (active on Low)
- (1) Generator AC (model 9621 only), 70 - 270 VAC rms, <50 to >60 Hz nominal
- (1) Magnetic pickup (model 9621 only), 3.5 - 21 VAC rms, <2000 to >6500 Hz nominal
Outputs (6):
- (3) Dedicated, +DC
  - Fuel: NO relay contacts, 10A max @ 24VDC
  - Start: Keyswitch contacts, 10A max @ 24VDC
  - Preheat: High-side FET (+DC), 1A
- (1) Dedicated, -DC (250mA)
- (1) Dedicated Alternator Excitation/Charge Fail Indication, +DC
- (1) Speed Calibration: to suit 0-1mA, 75 Ohm meter, output=0.75mA at rated engine speed
Communications:

Mating Connectors:
- Pre-stripped 8 to 10 mm. / 0.3 to 0.4 in. wire
Physical/Environmental:
- Enclosure Material: Polycarbonate / Polyester
- Dimensions (WxHxD): 3.8 x 3.8 x 3.7 in. (96 x 96 x 95 mm)
- Mass: N/A
- Weight: approx 0.7 lb. / 300g
- IP rating: IP67 & IP69K, IP66 Panel Seal with Gasket
- Operating Temperature: -35° to +55° C (-31° to 131° F)
- Storage Temperature: -35° to +55° C (-31° to 131° F)
- Vibration: N/A
- Shock: N/A
- EMC/EMI: EN55022, class B