PDM LSC mode via PGN 61184
Hi,
we are about to start config using the PDM to do some very simple switching of lights and fans, which by rights, doesnt need a screen as the switches are already there so we think we can use the PDM in local mode.
Before I try this and risk locking the PDM into local mode, am I right in saying that if we sent the PGN 61184 via CANCapture, to configure the PDM for local mode for specific DIs to drive specific DOs, the PDM would then operate in this way, even after power failure, until it recieved a 'NEW' 61184 that disabled the LSC for each output?
So our bench rig could be tested in this way, then reset, simply by reconnecting a screen that sends 61184 again to switch it back to 'normal' control?
Many thanks, Dave.
Please sign in to leave a comment.
Comments
0 comments