|
Overview: This guide is an outline of the critical steps in setting up OpenPV® Toolkit on a development computer and flashing/prepping a display. Details and images of the process can be found by clicking any section heading, which will open the appropriate detailed guide in another window, leaving this guide at its current location. Close the new window to return here. The guides covered in this quick start are: Before starting this guide, make sure to have a very strong small magnet that can be placed in the location shown HERE. |
Download and Install the OpenPV® Developer Toolkit for Windows:
➤ Install the downloaded program (OpenPV.Installer.msi)
Download Components & Install the STM Firmware Flashing Utility:
➤ Start the OpenPV® Developer Toolkit.
➤ Verify the version shown in the top bar of the window is 1.251 or newer.
➤ Click on the desired development Path in the left column.
➤ Click the Setup Profile button in the Actions pane on right to download the necessary components.
➤ Repeat the previous two steps for additional development paths desired.
➤ Allow The STM32Cube Programmer to install.
➤ Close and restart the OpenPV® Developer Toolkit before continuing.
Verify an Active Connection
➤ Verify the display is functional. (Power on and make sure the logo or installer screen appears.)
➤ Verify connection between Dev computer and Display (Listen for USB connect tone.)
Boot Display Into DFU Flash Mode
➤ Remove power from the display.
➤ Place small high-powered magnet on the triangle/circle icon on the back of the display.
➤ Supply power to the display while keeping the magnet in place.
Install Firmware on Display
➤ Start the OpenPV® Developer Toolkit.
➤ Click the Displays button in the Main Toolbar.
➤ Click the Flash Distribution button in the Actions side panel.
➤ Verify “Image Installed and device ready for Prep” is shown at the end of the Console journal.
Exit DFU Flash Mode
Install Platform Support Files to the Display ('Prep')
➤ Verify the correct model of display ("Platform Family") is selected. <-- This is critical in Prep.
➤ Click the Prep Display button in the Actions side panel.
The display should now be ready to Load a Demo Project by clicking the New button in the far left of the Main Toolbar.
Comments
0 comments
Please sign in to leave a comment.